[2024/04/09 22:07:00]
Ai Overclock Tuner [D.O.C.P.]
D.O.C.P. [D.O.C.P DDR4-3200 16-18-18-36-1.35V]
BCLK Frequency [100.0000]
SB Clock Spread Spectrum [Auto]
Performance Enhancer [Default]
Memory Frequency [DDR4-3200MHz]
FCLK Frequency [1600MHz]
CPU Core Ratio [43.25]
Core VID [Auto]
CCX0 Ratio [Auto]
CCX1 Ratio [Auto]
CCX0 Ratio [Auto]
CCX1 Ratio [Auto]
OC Tuner [Keep Current Settings]
Performance Bias [None]
PBO Fmax Enhancer [Disabled]
Precision Boost Overdrive [Disabled]
Precision Boost Overdrive Scalar [Auto]
Max CPU Boost Clock Override [Auto]
Platform Thermal Throttle Limit [Auto]
DRAM CAS# Latency [16]
Trcdrd [18]
Trcdwr [18]
DRAM RAS# PRE Time [18]
DRAM RAS# ACT Time [36]
Trc [Auto]
TrrdS [Auto]
TrrdL [Auto]
Tfaw [Auto]
TwtrS [Auto]
TwtrL [Auto]
Twr [Auto]
Trcpage [Auto]
TrdrdScl [Auto]
TwrwrScl [Auto]
Trfc [Auto]
Trfc2 [Auto]
Trfc4 [Auto]
Tcwl [Auto]
Trtp [Auto]
Trdwr [Auto]
Twrrd [Auto]
TwrwrSc [Auto]
TwrwrSd [Auto]
TwrwrDd [Auto]
TrdrdSc [Auto]
TrdrdSd [Auto]
TrdrdDd [Auto]
Tcke [Auto]
ProcODT [Auto]
Cmd2T [Auto]
Gear Down Mode [Auto]
Power Down Enable [Auto]
RttNom [Auto]
RttWr [Auto]
RttPark [Auto]
MemAddrCmdSetup [Auto]
MemCsOdtSetup [Auto]
MemCkeSetup [Auto]
MemCadBusClkDrvStren [Auto]
MemCadBusAddrCmdDrvStren [Auto]
MemCadBusCsOdtDrvStren [Auto]
MemCadBusCkeDrvStren [Auto]
Mem Over Clock Fail Count [Auto]
VDDCR CPU Load Line Calibration [Level 3]
VDDCR CPU Current Capability [130%]
VDDCR CPU Switching Frequency [200]
VDDCR CPU Power Phase Control [Extreme]
VDDCR CPU Power Duty Control [T.Probe]
VDDCR SOC Load Line Calibration [Level 3]
VDDCR SOC Current Capability [130%]
VDDCR SOC Switching Frequency [200]
VDDCR SOC Power Phase Control [Extreme]
VDDCR CPU Voltage [Manual]
VDDCR CPU Voltage Override [1.31875]
VDDCR SOC Voltage [Manual]
VDDCR SOC Voltage Override [1.10000]
DRAM Voltage [1.35000]
VDDG CCD Voltage Control [Auto]
VDDG IOD Voltage Control [Auto]
CLDO VDDP Voltage [Auto]
1.0V SB Voltage [Auto]
1.2V SB Voltage [Auto]
CPU 1.80V Voltage [Auto]
VTTDDR Voltage [Auto]
VPP_MEM Voltage [Auto]
CPU Core Current Telemetry [Auto]
CPU SOC Current Telemetry [Auto]
Security Device Support [Disable]
Disable Block Sid [Disabled]
Selects TPM device [Enable Firmware TPM]
Erase fTPM NV for factory reset [Enabled]
PSS Support [Disabled]
NX Mode [Enabled]
SVM Mode [Enabled]
SMT Mode [Auto]
Core Leveling Mode [Automatic mode]
CCD Control [Auto]
SATA Port Enable [Enabled]
SATA Mode [AHCI]
NVMe RAID mode [Disabled]
SMART Self Test [Enabled]
Hot Plug [Disabled]
Hot Plug [Disabled]
Hot Plug [Disabled]
Hot Plug [Disabled]
Hot Plug [Disabled]
Hot Plug [Disabled]
Hot Plug [Disabled]
Hot Plug [Disabled]
HD Audio Controller [Disabled]
PCIEX16_1 Mode [Auto]
PCIEX16_2 Mode [Auto]
PCIEX1_1 Mode [Auto]
PCIEX1_2 Mode [Auto]
PCIEX1_3 Mode [Auto]
M.2_1 Link Mode [Auto]
M.2_2 Link Mode [Auto]
SB Link Mode [Auto]
PCIEX16_1 Bandwidth Bifurcation Configuration [Auto Mode]
When system is in working state [All On]
When system is in sleep, hibernate or soft off states [All On]
Realtek LAN Controller [Enabled]
USB power delivery in Soft Off state (S5) [Enabled]
Serial Port [Disabled]
ErP Ready [Disabled]
Energy Star Ready [Disabled]
CEC Ready [Disabled]
Restore AC Power Loss [Power Off]
Power On By PCI-E [Enabled]
Power On By RTC [Disabled]
Above 4G Decoding [Enabled]
Resize BAR Support [Auto]
SR-IOV Support [Enabled]
Legacy USB Support [Enabled]
XHCI Hand-off [Enabled]
Generic-SD/MMC 1.00 [Auto]
Generic-SD/MMC/MS/MSPRO 1.00 [Auto]
USB Device Enable [Enabled]
U32G1_4 [Enabled]
U32G1_5 [Enabled]
U32G1_6 [Enabled]
USB8 [Enabled]
U32G2_C3 [Enabled]
U32G2_2 [Enabled]
U32G1_1 [Enabled]
U32G1_2 [Enabled]
USB9 [Enabled]
USB10 [Enabled]
Network Stack [Enabled]
IPv4 PXE Support [Enabled]
IPv6 PXE Support [Disabled]
Device [TOSHIBA-TR150]
CPU Temperature [Monitor]
CPU Package Temperature [Monitor]
MotherBoard Temperature [Monitor]
CPU Fan Speed [Monitor]
CPU Optional Fan Speed [Monitor]
Chassis Fan 1 Speed [Monitor]
Chassis Fan 2 Speed [Monitor]
Chassis Fan 3 Speed [Monitor]
AIO PUMP Speed [Monitor]
PCH Fan Speed [Monitor]
CPU Core Voltage [Monitor]
3.3V Voltage [Monitor]
5V Voltage [Monitor]
12V Voltage [Monitor]
CPU Q-Fan Control [Disabled]
Chassis Fan 1 Q-Fan Control [Disabled]
Chassis Fan 2 Q-Fan Control [Disabled]
Chassis Fan 3 Q-Fan Control [DC Mode]
Chassis Fan 3 Q-Fan Source [MotherBoard]
Chassis Fan 3 Step Up [0 sec]
Chassis Fan 3 Step Down [0 sec]
Chassis Fan 3 Speed Low Limit [600 RPM]
Chassis Fan 3 Profile [Manual]
Chassis Fan 3 Upper Temperature [70]
Chassis Fan 3 Max. Duty Cycle (%) [60]
Chassis Fan 3 Middle Temperature [45]
Chassis Fan 3 Middle. Duty Cycle (%) [60]
Chassis Fan 3 Lower Temperature [40]
Chassis Fan 3 Min. Duty Cycle (%) [60]
Allow Fan Stop [Disabled]
AIO PUMP Control [PWM Mode]
AIO PUMP Fan Q-Fan Source [MotherBoard]
AIO PUMP Upper Temperature [70]
AIO PUMP Max. Duty Cycle (%) [65]
AIO PUMP Middle Temperature [25]
AIO PUMP Middle. Duty Cycle(%) [65]
AIO PUMP Lower Temperature [20]
AIO PUMP Min. Duty Cycle (%) [65]
Above 4GB MMIO Limit [39bit (512GB)]
Fast Boot [Enabled]
Next Boot after AC Power Loss [Normal Boot]
Boot Logo Display [Disabled]
Bootup NumLock State [Off]
Wait For 'F1' If Error [Disabled]
Option ROM Messages [Force BIOS]
Interrupt 19 Capture [Disabled]
AMI Native NVMe Driver Support [Enabled]
Setup Mode [Advanced Mode]
Launch CSM [Disabled]
OS Type [Other OS]
Load from Profile [1]
Profile Name [TBO 4.3 STABLE]
Save to Profile [2]
DIMM Slot Number [DIMM_A2]
Download & Install ARMOURY CRATE app [Disabled]
Overclock [Auto]
Power Down Enable [Auto]
Cmd2T [Auto]
Gear Down Mode [Auto]
CAD Bus Timing User Controls [Auto]
CAD Bus Drive Strength User Controls [Auto]
Data Bus Configuration User Controls [Auto]
Infinity Fabric Frequency and Dividers [Auto]
Precision Boost Overdrive [Auto]
LN2 Mode [Auto]
SoC/Uncore OC Mode [Disabled]
VDDP Voltage Control [Auto]
VDDG Voltage Control [Auto]
NUMA nodes per socket [Auto]
LCLK DPM [Auto]
LCLK DPM Enhanced PCIe Detection [Auto]
Core Performance Boost [Disabled]
Global C-state Control [Auto]
IOMMU [Auto]
TSME [Auto]
Custom Pstate0 [Auto]
L1 Stream HW Prefetcher [Auto]
L2 Stream HW Prefetcher [Auto]
Core Watchdog Timer Enable [Auto]
Power Supply Idle Control [Auto]
SEV ASID Count [Auto]
SEV-ES ASID Space Limit Control [Auto]
Streaming Stores Control [Auto]
Local APIC Mode [Auto]
ACPI _CST C1 Declaration [Auto]
MCA error thresh enable [Auto]
PPIN Opt-in [Auto]
Indirect Branch Prediction Speculation [Auto]
DRAM scrub time [Auto]
Poison scrubber control [Auto]
Redirect scrubber control [Auto]
Redirect scrubber limit [Auto]
NUMA nodes per socket [Auto]
Memory interleaving [Auto]
Memory interleaving size [Auto]
1TB remap [Auto]
DRAM map inversion [Auto]
ACPI SRAT L3 Cache As NUMA Domain [Auto]
ACPI SLIT Distance Control [Auto]
ACPI SLIT remote relative distance [Auto]
GMI encryption control [Auto]
xGMI encryption control [Auto]
CAKE CRC perf bounds Control [Auto]
4-link xGMI max speed [Auto]
3-link xGMI max speed [Auto]
xGMI TXEQ Mode [Auto]
PcsCG control [Auto]
Disable DF to external downstream IP SyncFloodPropagation [Auto]
Disable DF sync flood propagation [Auto]
CC6 memory region encryption [Auto]
Memory Clear [Auto]
Overclock [Auto]
Power Down Enable [Auto]
Disable Burst/Postponed Refresh [Auto]
DRAM Maximum Activate Count [Auto]
Cmd2T [Auto]
Gear Down Mode [Auto]
CAD Bus Timing User Controls [Auto]
CAD Bus Drive Strength User Controls [Auto]
Data Bus Configuration User Controls [Auto]
Data Poisoning [Auto]
DRAM Post Package Repair [Default]
RCD Parity [Auto]
DRAM Address Command Parity Retry [Auto]
Write CRC Enable [Auto]
DRAM Write CRC Enable and Retry Limit [Auto]
Disable Memory Error Injection [True]
DRAM ECC Symbol Size [Auto]
DRAM ECC Enable [Auto]
DRAM UECC Retry [Auto]
Data Scramble [Auto]
DFE Read Training [Auto]
FFE Write Training [Auto]
PMU Pattern Bits Control [Auto]
MR6VrefDQ Control [Auto]
CPU Vref Training Seed Control [Auto]
Chipselect Interleaving [Auto]
BankGroupSwap [Auto]
BankGroupSwapAlt [Auto]
Address Hash Bank [Auto]
Address Hash CS [Auto]
Address Hash Rm [Auto]
SPD Read Optimization [Enabled]
MBIST Enable [Disabled]
Pattern Select [PRBS]
Pattern Length(MTS) [3]
Aggressor Channel [1 Aggressor Channel]
Aggressor Static Lane Control [Disabled]
Target Static Lane Control [Disabled]
Worst Case Margin Granularity [Per Chip Select]
Read Voltage Sweep Step Size [1]
Read Timing Sweep Step Size [1]
Write Voltage Sweep Step Size [1]
Write Timing Sweep Step Size [1]
Precision Boost Overdrive [Auto]
Precision Boost Overdrive Scalar [Auto]
FCLK Frequency [Auto]
SOC OVERCLOCK VID [0]
UCLK DIV1 MODE [Auto]
VDDP Voltage Control [Auto]
VDDG Voltage Control [Auto]
SoC/Uncore OC Mode [Auto]
LN2 Mode [Auto]
ACS Enable [Auto]
PCIe ARI Support [Auto]
PCIe ARI Enumeration [Auto]
PCIe Ten Bit Tag Support [Auto]
Max Voltage Offset [Auto]
cTDP Control [Auto]
EfficiencyModeEn [Auto]
Package Power Limit Control [Auto]
APBDIS [Auto]
DF Cstates [Auto]
CPPC [Auto]
CPPC Preferred Cores [Auto]
NBIO DPM Control [Auto]
Early Link Speed [Auto]
Presence Detect Select mode [Auto]
Preferred IO [Auto]
CV test [Auto]
Loopback Mode [Auto]
SRIS [Auto]
Data Link Feature Exchange [Disabled]